Item # 31067520Proud to introduce our new axle alignment kit! Machined to allow one person to take precise measurements of the car. No more estimating how to find center of frame tubes or axles. Ten piece kit that allows you to measure rear axle square, front axle wheelbase, lead, caster rotation of front axle, and spindle alignment. REQUIRED OPTION; To square the rear axle, rear chassis blocks are required under the rear cross tube of the frame. When ordering this kit be prepared to provide if this tube is 3/4", 7/8", or 1". So we can send the correct set of blocks.
Item # 31023000This bolt kit contains hardware that can be used for all three Grizz models; G7, G9, and G17.
Item # 21074001This washer is used in some specific places for shock and rod end hiems to allow proper spacing from components to eliminate bind.
Item # 21021002This steel plate can be bolted to the front of the belly pan to add 6 lbs. of weight to the car. These plates can also be doubled up. Dimensions 17.5"x11.5".
Item # 21021004This steel plate can be bolted to the rear section under the seat of the driver on top of the belly pan to add 4 lbs. of weight to the car. These plates can also be doubled up. Dimensions 11.5"x10.5".
Item # 21074300These pucks can easily be stacked on top of the steel weight plates or directly to the belly pan. Approximate weight is 3.5 lbs. per puck.
Item # 31068000This is a convenient bracket for the Mychron 5 Reciever to be mounted directly to the sheet metal body. Requires three holes to be drilled in the body to be mounted. Try to make sure the sensor is as flush as possible with the outside of the body for little to no interference. Sensor will need to be mounted so it is facing the outside of the track; to locate the beacon.
Item # 31043014Sold in packs of three. These hub nuts require a 1/2" socket and are for a 1/4-28 bolt thread.